Britax STARRISER COMFY Manuel du propriétaire télécharger pdf (Page 38)

Correct

Lower

anchorage point

8 a. e - -. :-

;ome vehicle seat belts cannot be used due to the position

rf the lower anchorage points both where your seat belt

rnd where the buckle are attached to the vehicle. Use the

rar guide on the appropriate side of this page to check

‘our seat belt anchorage points.

i either of the anchorage points falls outside of the black

irea, as shown, then you should use another position, for

sxample the middle of the rear seat using the lap belt.

Incorrect

Lower

anchorage point

Rear Seating Positions Are Safest

According to accident statistics, in a vehicle with rear designated

seating positions, children are safer when properly restrained in

rear seating positions than in front seating positions. As a rule, if

a lap-shoulder belt is available, use the rear middle position. The

second choice is the rear outboard position, on the curb side.

Use this restraint only on forward facing vehicle seats. Do not use

in rear-facing seats of station wagons or side facing seats. Read

this section carefully. If in doubt, return to the dealer for help.

DANGER: UNLESS THIS INFANT RESTRAINT IS USED IN A

VEHICLE EQUIPPED WITH A BABYSMART” AIRBAG

DEACTIVATION SYSTEM AND THE FRONT PASSENGER AIRBAG

IS OFF, BE AWARE OF THE FOLLOWING:

This restraint contains a special device that will automatically turn

off the airbag ONLY in BabySmart’” equipped vehicles. It MUST

NOT be used in the front seat of vehicles without the

BabySmart” System. Failure to do so may result in injury or death

to the infant. Owners of vehicles with front passenger airbags should

refer to their vehicle owner’s manual for child restraint installation

instructions.

Infant Restraint to its stable

mode. To do this, lower the

front and rear base

stabilizer feet until they click

into place. Always double

check that the base

stabilizer feet are locked

into place. In certain cases

it is possible that the front

support will not rest evenly

on the vehicle seat. This can

be remedied by placin

. . . .

. - -

; 1. You must adjust the

a towel or blanket underneath

2. For proper support of the child’s head, with the infant already

’ secured in the Infant Restraint, PLACE THIS INFANT RESTRAINT

IN A REAR-FACING POSITION WHEN USING IT IN THE VEHICLE.

This means the child is looking toward the back of the vehicle. This

restraint may only be used in the rear facing position. If installed in

the front passenger seat of a vehicle with BabySmartru, recheck

that the airbag is off. “Airbag Off” lamp on instrument panel will

illuminate.

3. The carrying hand11

should be in the “A” carryinj

position.

4. Pull out and buckle the

vehicle’s seat belt, without

attaching it to the Infant

Restraint.

5. Place the lap portion of

the belt in the belt guides

on both arm rests of the

Infant Restraint and tighten

by pulling on the shoulder

portion of the belt.

- .\

- Direction of travel

6. Open the cover panel on the back of the Infant Restraint. Pull the

shoulder belt out to its furthest length. Insert the shoulder belt into

the belt guide on the back of the seat shell. Make sure that the belt

is not twisted.

7. Holding the top of the Infant Restraint firmly in place with one

hand, pull the shoulder belt tight with the other hand.

Do not pull the shoulder belt up so that the Infant Restraint

lifts off the seat of the vehicle. The Infant Restraint must remain

flush against the vehicle seat.

8. Firmly close the cover panel to clamp the shoulder belt in place.

The cloth restraint covering must not be caught between the cover

panel and the seat shell. By pressing on the cover latch check that

the trim panel is securely closed.

Mercedes-Benz Infant Restraint page 3 of 6

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Britax STARRISER COMFY Manuel du propriétaire Page 38

Commentaires sur ces manuels

Produits connexes et manuels pour Siège de voiture Britax STARRISER COMFY