Britax STARRISER COMFY Manuel du propriétaire Page 51

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 56
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 50
b)
cl
dl
e)
Switch off the front passenger airbag by insertin
the
disconnection belt tongue (fi . N, 18) on the Porsche
es
Safe into the disconnection 6
aby-
elt buckle in front of the front
passenger seat (fig. VIII, 18). The red disconnection belt
should be left slack.
Ensure that the tongue for switching off the front, passenger
airbag is correctly Inserted as follows. Turn the Ignition key
to the on position (position 2). The airbag warnrng Ii ht in
the instrument panel should flash for 10 seconds an d then
go off, indicatin
IS switched off. !
that the Porsche front passenger airbag
ee your Owner’s Manual for further details.
If you cannot confirm that the air ba
not use the Porsche Baby-Safe. E
is turned off do
heck with your
Porsche dealer for assistance.
Pull out the car seat belt and insert in the buckle (see figure
VII.
Place the lap belt portion (fig. VII, 14) of the car seat belt
over the armrests of the Porsche Baby-Safe and insert into
the belt
B
uides (fig. VII, 15) on both sides of the Porsche
Baby-Sa e. Pull the belt snug over the Porsche Baby-Safe.
Open the cover (fig. WI, 4) usin
the clasp (fig. VII, 5). Pull
the shoulder belt portron (fig. si
I, 13) behind the Porsche
Bab -Safe seat back and insert it between the belt clip (fig.
VII r6) and seat back (fig. VII 17). Ensure that the car seat
beit fits snugly and is not twisted.
Close the cover (fig. VII, 4) and lock in position in order to
engage the shoulder belt portion (fig. VII, 13). The cloth seat
coverin must not be trapped between the cover (fig. VII,
4) and t fl e seat back. By pressing on the clasp (fig. VII, 5)
make sure that the cover (fig, VII, 4) is closed fully.
Illustrations VIII and IX show the correct path for the seat belt,
with the cover closed and the front passenger airbag
disconnection belt and buckle inserted in the proper location.
4
Care and maintenance
What comes after the Porsche Baby-Safe?
Remove the cloth covering and wash it carefully in a mild detergent
and warm water (30°C) and hang to dry. Do not spin or machine dry.
If the safety harness buckle malfunctions
Children over 20 lb (9 k ) should be restrained in a Porsche
PrinCe
child seat or a Porsche 5 oom booster seat (with or without Comfy
sleep rest.) as their size indicates, Please check with your Porsche
dealer for details.
If both tongues cannot be inserted, press the red pushbutton all the
way down, then insert the two tongues together. If the safety harness
buckle malfunctions, this may be due to contaminants which can be
washed out. Malfunctions can usually be identified by:
- The tongues engage without a pronounced “Click”.
-The tongues are elected slowly after pressing the
release button.
- Insertion of the tongues is difficult.
. The tongues will not engage (are ejected again).
What to do
Try the following corrective steps. If these do not fix the
problem, do not use the Porsche Baby-Safe until the malfunction
has been repaired.
1.
Remove the safety harness buckle
Push the buckle downwards in the belt slot. You can now
reach the metal plate under the seat area used to secure
the belt to the seat base and push it up through the slot in
the seat base, allowing the buckle to be removed from the
seat
2. Cleaning the buckle
Soak the buckle portion (for at least 30 min. or possibly
overnight) in hot water (possrbly with detergent). Then rinse
out the buckle and dry it thoroughly.
3. Refitting
Reinstall In reverse order of step 1. You must make sure
that the metal plate is pressed back through the slot of the
plastic seat base and is not just fastened beneath the
coverrng. If In doubt of correct rnstallahon contact your
Porsche dealer.
Warning:
l
This child seat provides effective protection only when it
is used and installed properly in accordance with instructions
in this booklet.
The Porsche Baby-Safe is designed, tested and ap
in accordance with the re
%
uirements of US Federa P
roved
Motor
Vehicle Safety Standard 13 governing child restraints.
The backrest of the vehicle seat must be properly secured.
There should be no heavy,
shar
the car (e.g. on the parcel shetf
P
-edged
which
or loose objects in
may strike the child
or other occupants in an accident and cause injury.
Zfeyi;lems arise during use, please contact your Porsche
No modifications may be made to the Porsche Baby-Safe.
The child seat may be damaged after an accident with an
impact speed above 6 mph (10 km/h). The Porsche Baby
Safe must then be checked for damage and replaced if
necessary.
So that your child does not contact hot items, the Porsche
Bab -Safe should be covered with a blanket or towel and
not z e left in direct sunlight.
Never leave your child alone or unattended in the child
seat or in the car.
If the Porsche Baby-Safe is carried in the car without a
child, it must be secured with the belt.
6
Britax BRITAX Child Safety, Inc.
460-R Greenway Industrial Drive
Fort Mill, SC 29715
ISSUE 1
Porsche Baby-Safe TM Rear Facing Infant Restraint and Carrier page 3 of 3
Vue de la page 50
1 2 ... 46 47 48 49 50 51 52 53 54 55 56

Commentaires sur ces manuels

Pas de commentaire