Britax STARRISER COMFY Manuel du propriétaire télécharger pdf (Page 33)

Rear Seating Positions are Safest

According to accident statistics, in a vehicle with rear designated

seating positions, children are safer when properly restrained in

rear seating positions than in front seating positions. Use only rear

seating positions equipped with three point lap-shoulder belts.

As a rule, if a lap-shoulder seat belt is available, use the rear middle

position. Otherwise, the second choice is the rear outboard position,

on the curb side. If the vehicle has only lap belts in the rear, do not

use this restraint on the rear seat.

DANGER: UNLESS THIS BOOSTER SEAT IS USED IN A VEHICLE

EQUIPPED WITH A BABYSMARTT”” AIRBAG DEACTIVATION

SYSTEM AND THE FRONT PASSENGER AIRBAG IS OFF, BE

AWARE OF THE FOLLOWING:

This restraint contains a special device that will automatically turn

off the passenger side front airbag ONLY in BabySmart” equipped

vehicles. It MUST NOT be used in the front seat of vehicles

without the BabySmartnl System. Failure to do so may result in

injury or death to your child. Owners of vehicles with front passenger

air-bags should refer to their vehicle owner’s manual for child restraint

installation instructions.

Seat Orientation

The Booster Seat is not intended for use in vehicle seats that are

side facing. Do not use it in such seats.

The purpose of the belt-adjusting Booster Seat is to adapt the adult

webbing of the vehicles three point lap-shoulder seat belts to the

body of the child, so it is important to adjust the width correctly.

Adjusting the width of the Booster Seat before installation in

the vehicle.

1. Lift the flap located on

the bottom of the Booster

Seat and pull the sides of

the booster seat apart.

2. While your child is

standing, position the arm

rests of the Booster Seat to

be snug against the hips of

the child, so as to bring the

lap portion of the three

point lap-shoulder belt

close to the body.

Fla

Arm Rests

3. When the width has been correctly adjusted, close the flap located

on the bottom of the Booster Seat.

4. As your child grows, you WIII have to re-adjust the width of the

Booster Seat.

Attaching the Backrest

To The Booster Seat

1. Open the cloth slots at

the rear of the Booster Seat.

Insert the connectors into

the slots and push down to

lock into place. Pull

upwards on the Backrest to

assure that it is fully

connected.

2. After checking the

Backrest installation insert _

the wedges into the slots

behind the connectors.

Push down until the wedges

lock into place. Recheck

your Backrest to ensure

that it is installed correctly

as shown.

WARNING! Leave the

wedges attached to the

Backrest. If not attached,

the wedges could be lost or

fib

Wedge

Inserted II

Position

pose a choking hazard for children.

3. Bring the Backrest forward and stow the shoulder belt adjuster

clip onto the back base of the Backrest by sliding it into place on the

storage plate. Do not pull the strap tight.

Removing the Backrest from the Booster Seat

Remove the wedges by pulling upwards. Press the lower part of both

connectors at the point marked “Press” and pull the Backrest upwards.

Adjusting the Height of

Unzip the back cover of the

Backrest. Push the “Press”

button and pull the Backrest

upwards, out of the slots.

Refit to the desired height

(so that the shoulder belt

guides are just slightly

above the child’s shoulder).

Slide down until the “Press”

button clicks into place.

Close the zipper.

Adjusting the Backrest to fit the Vehicle’s Seat.

Pivot the Backrest so that it rests flat against the seat back of the

vehicle. If necessary, adjust the vehicle’s headrest to allow the

Backrest to lie flat.

Mercedes-Benz Child Booster Seat With Backrest page 2 of 4

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Britax STARRISER COMFY Manuel du propriétaire Page 33

Commentaires sur ces manuels

Produits connexes et manuels pour Siège de voiture Britax STARRISER COMFY