Align each LATCH strap on the LATCH bar with 6
the “LATCH Strap Here Rear-Facing” label on
each side of the child seat. (Figs. E and F).
Push the child seat firmly into the vehicle seat 7
while pulling each LATCH strap tight (Fig. G).
IMPORTANT: Ensure the LATCH strap does not
fold into the LATCH adjuster while tightening.
Verify that all connections are secure, the 8
LATCH strap is aligned to the “LATCH Strap
Here Rear-Facing” label on each side of the
child seat, and that the child seat is stable.
The child seat is secure when it cannot be •
moved more than 1 in. (2.5 cm) front-to-back
or side-to-side at the belt path. If the child seat
is not secure, repeat the installation process
or use an alternate seating location.
When properly installed in the rear-facing •
position, the back angle of the child seat
should be 30º – 45º from vertical (not to
exceed 45º) when the car is parked on a level
surface (Fig. H).
If necessary, the proper recline angle can be •
achieved by placing a rolled towel or pool
noodle in the vehicle seat bight to level the
child seat’s base.
Rear-facing installation can be improved by •
the use of the Versa-Tether.
See pages 29 – 32.
g
f
e
LATCH Installation
Figure A illustrates a rear-facing LATCH •
installation.
Verify that your vehicle is equipped with •
LATCH anchors. If LATCH anchors are not
available, you must use the vehicle belt
installation methods.
If stored, remove the LATCH connectors from 1
the storage slots under the cover (pg 33), open
rear-facing lock-offs, and pass them through
their adjacent rear-facing belt slots to the
outside of the child seat.
Press and hold the first LATCH adjuster release 2
button, then pull the LATCH strap to full length.
Repeat for the remaining LATCH connector.
Recline the child seat and place rear-facing on 3
the vehicle seat. This child seat must be in the
reclined position when installed rear-facing.
See Recline Adjustment on page 33.
Attach one LATCH connector to its adjacent 4
vehicle LATCH anchor (Fig. B) in the upright
position (Fig. C).
An audible click confirms attachment.•
Ensure that the LATCH strap is not twisted.•
TIP:
You may need to turn the front of the child
seat toward you for easier access to the
vehicle LATCH anchor.
Attach the remaining LATCH connector to its 5
adjacent vehicle LATCH anchor (Fig. D) in the
upright position (Fig. B).
An audible click confirms attachment.•
Ensure that the LATCH strap is not twisted.•
NOTE:
If an audible click is not heard when
connecting either LATCH connector, the LATCH
strap may be twisted, or there may be debris in
the LATCH connector. Correct either situation
before continuing with the installation process.
d
a
b
h
WARNING! Do not raise the child
seat off the front edge of the vehicle seat.
This could cause your child seat not to
perform as intended.
Installation: Rear-Facing Installation: Rear-Facing
c
Release
Button
Top
(10 pages)
(47 pages)
(31 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels