Britax 7300 A 2010 Guide de l'utilisateur Page 15

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 24
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 14
26
27
Lap-Belt Installation
Figure A illustrates a forward-facing, lap-belt •
installation.
When not in use, always store the LATCH •
connectors in the storage slots. See page
33.
IMPORTANT: Britax recommends that the Versa-
Tether be used at all times. Using the tether will
improve the stability of the child seat and reduce
the risk of injury. Check your vehicle owner’s
manual for approved tether locations.
Place the child seat forward-facing on the 1
vehicle seat. Ensure the bottom of the child
seat base is in full contact with the vehicle
seat.
TIP: You may need to raise or remove the vehicle
head restraint to achieve best fit of the child
seat.
If the vehicle is equipped with a designated 2
tether anchor for the chosen seating position, remove the Versa-
Tether
from the pouch and place it up and over the child seat back.
Pull the vehicle belt out, then pass it 3 under the LATCH bar, through
the forward-facing belt path, then under the LATCH bar on the
opposite side (Fig. B).
TIP: The side impact cushions can be rotated for better access to the belt
path during installation (Fig C).
Verify that the vehicle belt is not twisted, is 4
routed under the LATCH bars, then buckle
(Fig. B).
TIP: Turning the back of the child seat toward you
can make routing the vehicle belt easier (Fig. D).
Push the child seat firmly into the vehicle 5
seat while removing slack from the vehicle
belt (Fig. E).
Attach the Versa-Tether6
®
hook to the
designated tether anchor (if available
according to the vehicle owner’s manual)
for the chosen seating position. Remove all
slack from the tether to secure. Store excess
webbing in the tether pouch. See pages
29 – 32.
Verify that the vehicle belt is tight, locked 7
and the child seat is secure.
The child seat is secure when it cannot be •
moved front-to-back or side-to-side more
than 1 in. (2.5 cm) at the belt path. If the child seat is not secure,
repeat the installation process or use an alternate seating location.
a
b
d
e
WARNING!
This child seat must not be used forward-•
facing for children less than one year of age
OR who weigh less than 20 lbs (9.1 kg).
This child seat must be in full upright position •
when installed forward-facing for children who
weigh more than 33 lbs (15.1 kg).
Installation: Forward-Facing Installation: Forward-Facing
c
Vue de la page 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Commentaires sur ces manuels

Pas de commentaire