Britax 7300 A 2010 Guide de l'utilisateur Page 20

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 24
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 19
36
37
Adjusting the Harness Height
IMPORTANT:
See Important Harness
Adjustments on pages 6–7 for instructions on
proper harness fit based on your child’s height
and weight.
Loosen the harness by lifting the harness 1
adjuster lever while pulling both harness
straps forward as far as possible (Fig A).
Rotate the head restraint adjustment knob 2
on either side of child seat to raise or lower
the head restraint and harness (Fig. B).
NOTE: DO NOT force the head restraint
adjustment knob in either direction. If the knob
is difficult to turn, the head restraint may be at
maximum or minimum height, the harness may
be tight, or the child’s weight is pressing against
the head restraint cover.
TIP: The side impact cushions can be moved for
easier access to the head restraint adjustment
knob.
Buckling and Tightening the
Harness
Loosen the harness by lifting the harness 1
adjuster release lever located on the front
of the child seat while pulling both shoulder
straps forward (Fig. C).
Release the chest clip by squeezing the tabs 2
and sliding the pieces apart (Fig. D).
Unfasten the harness buckle by pressing the 3
release button and sliding the tongues out.
Move the harness straps to the side of the 4
child seat.
Use the harness holders located on the •
straps and both sides of the cover to aid in
holding the straps.
IMPORTANT: Remove bulky coats and/or
jackets before putting the child in child seat.
Adjust the harness to fit the clothes the child is
wearing.
Place child in the child seat.5
Position harness straps around the child and 6
fasten harness buckle (Fig. E) and chest clip
(Fig. F).
Proper connection of the harness buckle •
is confirmed with an audibe click after
inserting each buckle tongue.
If the buckle will not fasten with an audible •
click after insertion of each buckle tongue,
the harness buckle or adjuster area may
be clogged with food, drink or other debris
that needs to be removed. See page 39 for
cleaning instructions.
Slide the HUGS7 chest pads down towards the buckle.
Important checklist before tightening the harness:
Check for proper harness height (see pages 6 – 7). 9
Remove slack from around the child’s upper thighs. 9
Remove slack between the HUGS™ chest pads and the buckle. 9
a
b
c
d
e
f
Securing Your Child Securing Your Child
Vue de la page 19
1 2 ... 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire