Britax JS8A/2010 Manuel d'utilisateur télécharger pdf (Page 51)

Instructions for Installation & Use - Series No. JS8A/2010

HOW TO INSTALL WITH A CHILD HARNESS

BOOSTER MODE

WITH CHILD HARNESS

G. Finally, roll up the free end of the adjuster strap,

secure using the storage strap, then place it into

the top of the adjuster cover as shown right.

Fold the

adjuster strap

and secure

with storage

strap

F. With the lap belt (or converted lap/sash) adjusted to

be a rm t on the child's thighs, then adjust the child

harness to remove slack in the shoulder straps. Pull

the adjuster strap (C) to remove slack.

Once adjusted, further adjustments are necessary only

to the upper extension straps and to accommodate the

growth of the child.

Press (A) and pull the shoulder strap (B) to lengthen.

Adjuster Cover

Storage Strap

Fully press adjuster button

(A) while pulling the Upper

Anchorage Strap (B) to lengthen.

Adjuster

Pull Adjuster

strap to

remove

slack

The lap portion of the belt must be adjusted rmly rst, and then the harness, so that the belt is

not lifted off the child's lap when the harness is adjusted.

CAUTION:

NOTE: The shoulder straps must be in the slots which

are nearest to the child’s shoulders but no lower than

the child’s shoulders. This is achieved with the headrest

slightly above the child’s shoulders.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 67 68

Pas de commentaire

Britax JS8A/2010 Manuel d'utilisateur Page 51